One important thing to take note of, in a ping test output is the time at the end of each ping reply.Īssuming you are carrying out ping testing on your servers, then the value here matters a lot, depending on the type of application you are running on a server. Rtt min/avg/max/mdev = 4.751/5.030/5.373/0.222 msįrom the results of the above command, the ping was successful and there were no packets lost. You can also use an IP address instead of the domain name as shown. You can run a simple ping test to see whether the target host is reachable or not. DoS Attack with Ping Flooding aka Ping of Death In case a ping test fails, you will see error messages as output. It also shows a statistical summary of the test, typically including the number of packets transmitted and those received, the percentage of packet loss the minimum, maximum, the mean round-trip times, and the standard deviation of the mean ( mdev). Its output is a list of replies from the target host along with the time taken for the last packet to reach the target host and back to your computer. The packet loss is expressed as a percentage.To measure the amount of time it takes for packets to get to the target host and back to your computer (the round-trip time ( rtt) in communicating with the target host) and.Whether the target host is reachable (active) or not.You can run a ping test in order to establish if your computer can communicate with another computer (target host) it helps you determine:
Maximum ping console command series#
It works by sending a series of Internet Control Message Protocol ( ICMP) ECHO_REQUEST messages to the target host and waiting for an ICMP echo reply (or ECHO_RESPONSE). Ping is a simple, widely used, cross-platform networking utility for testing if a host is reachable on an Internet Protocol ( IP) network.
0 kommentar(er)
